Job # 2029 (CB) - Jaguar Mk II Full Stage One HP engine rebuild

I am pleased to report that we have now completed this Stage One high performance engine rebuild.
 
 

Crank has been ground, polished and modified for upgraded rear seal	Measuring deck height
	ARP main and rod bolts
	Finished engine a thing of beauty

We have now completed the rebuild of your cylinder head. You will see from the flow charts below that we picked up almost 60 cfm on the intake, which should translate into big power gains.

Baseline flow numbers on intake	Flow test after porting showed huge gain of 58.7 cfm
Pressure testing head after port work	Surfacing head
	Final assembly in progress

Cylinder head rebuild underway....

Tappet guides all out of spec and will be replaced	Base line flow testing before port work
Sizing pockets for new CJ seats	Intake venturis will be opened up to match oversized CJ seats
Chris hard at work in the porting room

The block has now been align honed, the cylinders have been honed to size, and the deck surface has been surfaced.

Align hone in progress	Measuring relative deck height of new top hat sleeves
Pulling sleeves	Surfacing block with timing chain cover installed
	Block now ready for assembly

Tear down was a messy business with this engine!

As grimy a timing chain cover as you will ever see!	We needed to use the crane to remove the cyl head

I am pleased to report that your engine and carbs arrived safely and we already have your Stage One rebuild underway.