Viper - Stage One heads, CEM camshafts
| Job
# 1830 (PP)
Viper - Stage One heads, CEM camshafts |
|
 |
|
CNC machined billet main caps for Dodge Viper |
Report date - February 20, 2008
With your CM Stage One heads installed, as well as Harold Hallam's exclusive CM camshafts, a cold air intake and a set of headers, we put the car on the chassis dyno earlier this morning. The results were quite satisfying, to say the least.Using a stock Gen III Viper as a benchmark (428.48 rwhp and 464.72 ft/lbs of torque), we have added more than 133 horsepower to the back wheels, as well as another 75 ft/lbs of torque. Your car actually produced 561.73 rear wheel horsepower and 539.01 ft/lbs of torque. The Dyno sheet is reproduced for you below.
 |
 |
 |
Report date - February 15, 2008
We have now completed the rebuild of your Viper cylinder heads and should have them installed back in the car early next week.
 |
 |
 |
 |
 |
 |